User manual

Doc# 27-0005UM Issued 11/00 Rev 1.0
TOOLS REQUIRED
PRECAUTIONS
Required Tools and Equipment
 Phillips screwdriver with about 10"
shaft.
In preparation to install the StarGate,
take the following precautionary
steps:
Verify the StarGate power switch is off.
If the power is off, the light on the front
panel will not be illuminated.
WARNING: To avoid shock
hazard:
 Do not connect or disconnect
the unit during an electrical
storm.
 The power cord plug must be
connected to a properly wired
and grounded power outlet.
 Any equipment to which the
unit will be attached must also
be connected to properly wired
and grounded power outlets
 The socket outlet shall be
installed near the equipment
and shall be easily accessible.
.
NOTE: For the fastest and
easiest installation of
the StarGate, follow
these steps in the
sequence they are
presented.
6
Starting Point