COMMAND CONSOLE Monitor User Manual 14

Doc# 27-0001UM Issued 7/99 Rev. 1.2

INSTALL HARDWARE

· Install the slide assemblies to the rack by installing three screws (V) to the

front and three screws (W) to the rear.

· Tighten the hex nuts (U) that were installed in the previous page.

· Install the command console (FF) into the rack slides.

U. 01-91802 Nut 8-32 Nylon Hex

V. 01-92087 Scr, 10-32 x .375 Low Hd

W. 01-92097 Scr, 10-32 x .625 Pan Hd

FF. Command Console