Installation Sheet

1 of 2
INSTALLATION INSTRUCTIONS
Model 592F;593F
Fig.1
A
B
C
D
E
F
G
H
I
J
K
L
Fig. 2
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green or
Bare
Copper(
Ground)
FOR YOUR SAFETY WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING ON IS SHUT OFF; EITHER
THE FUSE IS REMOVED OR THE CIRCUIT BREAKER IS SHUT OFF.
CAUTION: THE PRODUCT SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN THAT IS AWARE OF THE CONSTRUCTION
AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED
GENERAL You don’t need special tools to install this fixture. Be sure to follow the steps in the order given. Under no
circumstances should a fixture be hung on house electrical wires, nor should a swag type fixture be installed on a
ceiling which contains a radiant type heating system. Read instructions carefully. If you are unclear as to how to
proceed, consult a qualified electrician.
NOTE: Proper wiring is essential for the safe operation of this fixture.
MOUNTING THE FIXTURE (Fig. 1)
1. Shut off the power at the circuit breaker and remove the
old fixture, including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to miss any small
parts necessary for installation.
3. If you are replacing an existing fixture, remove and
disconnect the old fixture
4. Attach the mounting plate (C) to the outlet box (A) (not
supplied) with the box screws (D). GND must face out.
Connect the electrical wires as follow:
5. Connect Black wire from the fixture to the black (hot)
supply wire from outlet box; connect the white wire from
the fixture to the white (neutral) house wire from outlet
box. Make sure all wire nuts are secured properly. You may
wrap the connections with electrical tape. If your outlet has
a ground wire (green or bare copper). Connect fixture’s
ground wire to it. Otherwise, connect fixture’s ground wire
directly to the mounting plate using the green screw
provided. Tuck the wire connections carefully into the
outlet box.
THE INSTALLATION (Fig.1)
6. Rise the fixture ceiling pan (E) onto the mounting plate
(B) to be secured with ball knobs (F).
7. Install the bulb (Not provided) into E12 Candle base in
accordance with the fixture’s specification.
Install glass Shade (G) and the metal cross (K). (Fig.4)
8. Assemble the glass shade (G) to the fixture ceiling pan (E) .
Then put gasket (H) and washer (I) at the bottom of the
glass shade (G), after that, tighten them with hex nut (J)
on the center rod. rise the bottom metal cross (K), secure
it with the bottom finial(L) underneath the Glass shade.
DO NOT EXCEED THE MAXIMUM WATTAGE
RATING!
Your installation is now complete. Return power to
the junction box and test the fixture.