Energy guide

III. Assembling Of Hopper

1. Insert Hopper Assembly II (61) into Hopper Assembly I (3) so the bolt holes are aligned.

2. Insert the Bolts (60) through the holes in the Hopper.

3. Open the Hopper Lid and attach the Hexagon Kep Nuts (63) on the inside of the Hopper Assembly II.

(61), then tighten it from inside.

4. Cover the hopper mouth while installing the handle. Screws may fall into the hopper mouth. Insert

Hexagon Bolt (58) through Gasket (57) and lid (9) directly to the handle and tighten up. Warning: Do not

screw too tight.

58 57