User Guide

10-1-2013 9

Installation Manual CoxDENS

PPs

TERMINATION

Vertical Termination

• If the position of the roof terminal is speciﬁ ed, make a

hole in the roof:

a) For terminal Ø60/100mm (Ø2”/4”) and Ø80/125mm

(Ø3”/5”) with a minimum of Ø130mm (Ø5,5”) depending

on the roof sloping;

b) For terminal Ø110/160mm (Ø4”/6”) with a minimum of

Ø170mm (Ø7”) depending on the roof sloping;

• For a good water seal, install the correct roof ﬂ ashing on

the roof;

• Install the roof terminal vertically through the roof ﬂ ashing

and ﬁ x them with the support to the inside of the roof;

• The roof terminal is now ready to connect with the other

vent parts.

Typical sloping roof situation

Typical ﬂ at roof situation