Brochure

9 10
Vertical Vertical Kit
Horizontal
Horizontal Kit
Additional Terminations
Z-DENS Concentric
Terminations
Z-DENS CONCENTRIC TERMINATIONS are suitable
for any condensing appliance.
Designed with exceptional features including; modern
appearance, outstanding aerodynamics, rain water
management, cleaning and concentric or collinear
(horizontal & vertical kit) options.
Vertical Design Features:
• Upper roof part is made of black RAL9005; UV resistant
polypropylene for 2”/4” (60/100 mm) and 3”/5” (80/125
mm) or aluminum cap and galvanized outer air intake pipe for
4”/6” (110/160 mm)
• Outer air intake pipe below roof is made of white RAL 9016
galvanized steel
• Flue pipe is made of fire retardant polypropylene
• Icicle-Free - The cap allows some rain water to enter vent
reducing icicle formation and aids in diluting PH of condensate
• Aerodynamics - Outstanding aerodynamic behaviour, with very
low influence of wind
Horizontal Design Features:
• Outer wall part is made of grey RAL7001 UV resistant
polypropylene for 2”/4” (60/100 mm) and 3”/5” (80/125
mm) or white RAL 9016 aluminum end and galvanized outer air
intake pipe for 4”/6” (110/160 mm)
• Flue pipe is made of fire retardant polypropylene
• Nozzle/Water Outlet - The specially designed nozzle end
prevents ingress of rain water. A collector with drip edge makes
sure rain water and condensation are drained directly to the
ground and not down the wall.
• Aerodynamics - Outstanding aerodynamic behaviour, with very
low influence of wind
• Removing/Cleaning - The removal to clean nozzle end is
simple, only a screw driver is needed
Z-DENS ADDITIONAL TERMINATIONS
• Z-DENS has additional UV resistant polypropylene terminations
including; pipes, 45° and 90° elbows all for use with stainless
steel end screens.
• Z-DENS has additional stainless steel terminations including:
tees with built in screens and horizontal low profile kits.