Pocket Guide

Intertek Tested, Approved
& Listed to ULC S636 as
a Type BH Gas Vent System
Z-DENS
Polypropylene Vent System
Part ID Description
2ZDCPVC
(2,3,4,6)
CPVC/PVC
Coupling
2ZDCPVCF
(3,4,6)
CPVC/PVC
Pipe
2ZDCPVCG
(2,3,4,6)
Appliance
w/ Gasket &
Clamp
CPVC/PVC
2ZDCPVG3L
US Boiler
Alpine
Wall Mount
2ZDCPVCS
(3,4)
Bosch
Greentherm
& Therm
2ZDLAMT0
(6,8)
Laars
MagnaTherm
2ZDWASF100
(6,8)
Weil McLain
Slim Fit
®
rev: 04.2016
Installation Notes:
1. Refer to appliance I/O manual for:
— Approved vent type
— Appliance Adaptor
— Vent Configurations
2. Ensure joints are fully seated
3. Z-DENS locking clamps on each joint
4. Use UV resistant Z-DENS parts where
exposed to sunlight
5. Follow Z-DENS Installation Manual(s)
6. Visit www.z-flex.com for complete list
of appliance adaptors, parts and
instructions.
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
• SINGLE WALL RIGID
• FLEXIBLE LINER
• CONCENTRIC
U.S.A. tel: [phone]
CANADA tel: [phone]
www.z-flex.com email [e-mail]
Appliance Adaptors*
*Partial list. For complete adaptor listing visit
www.z-flex.com/information center