User Guide

8 10-1-2013

TERMINATION

Vertical Termination

• If the position of the roof terminal is speciﬁed, make a

hole in the roof:

• a) For terminal ∅ 60/100mm (∅ 2”/4”) and ∅80/125mm

(∅ 3”/5”) with a minimum of

∅ 140mm (∅ 5,5”) depending on the roof sloping;

• b) For terminal ∅ 110/16 0 m m (∅ 4”/6”) with a minimum

of ∅ 170mm (∅ 7”) depending on the roof sloping;

• For a good water seal, install the correct roof ﬂashing on

the roof;

• Install the roof terminal vertically through the roof ﬂashing

and ﬁx them with the support to the inside of the roof;

• The roof terminal is now ready to connect with the other

vent parts.

Typical sloping roof situation

Typical ﬂat roof situation