Brochure

Stainless Steel Chimney System
7/8
Flex Ready
Lock N’Go Tee
(Cleanout)
• 3pc. with removeable
snout and clean out
• All stainless steel
• Fail-safe mechanical
connection from snout
to body
When to Z-FLEX
®
a Chimney
• When a masonry chimney has no liner at all
• When damage to existing chimney lining is evident
• When new burner is installed on existing equipment
• When firing rate of existing burner is reduced
• When a new appliance is connected to an existing chimney
• When the existing chimney is oversized relative to heating equipment
Nose Cone
Part No.: 2NCXXXX
Dia.:
Dia.: 3” – 24”
To attach to liner, attach rope
to cone and pull rope down
chimney.
Top Support
Part No.: 2ZTSXXX
Dia.:
Dia.: 3” – 24”
Stainless
Steel Flex Liner
Part No.: 2ZLSSXX
Dia.: | Lgth.:
Part No.: 2ZL294C
Dia.: | Lgth.:
Dia.: 2” – 24”
Lengths : Up to 50’ or
multiples of 5’.
Reducer/Increaser
Reducer Part No.: 2RD
(Dia)R: (Dia)X:
Increaser Part No.: 2IN
(Dia)R: (Dia)X:
Dia.: 3” – 24”
Lock N’Go Tee
Part No.: 2ZFTXX
Dia.:
Dia.: 3” – 24”
Z-FLEX
®
Tee supplied.
Flex Ready Rigid Tee also
available.
Rain Cap
Part No.: 2RNCAPS
Dia.:
Dia.: 3” – 24”
Dripless Type “A”
Connector
Part No.: 2CNNTRC
Dia.:
Dia.: 3” – 24”
Used to mate Z-FLEX
®
Liner
to stove-pipe or when going
through a fireplace insert.
Insulating Blanket
w/Wrap & Gear Clamps
Part No.: 2INSKIT
Dia.:
Includes 2 gear clamps per
5’ section.
Stainless Steel
Chimney Flashing
Starter Collar 16” x 16” Base
Part No.: 2ZSCSXX
Dia.:
Dia.: 3” – 24”