Selection Guide

ManualsBrandsZ-FLEX ManualsAppliance Adapters4" to 3" Reznor Appliance Adapter

Canada: 452 Attwell Drive, Etobicoke, ON M9W 5C3 tel: 416.679.0045 • fax: 416.679.0051

U.S.A : 20 Commerce Park North, Bedford, New Hampshire 03110 tel: 603.669.5136 • fax: 888.889.3539 • 800.654.5600

rev 30.11.2021

® ®

Z-VENT

Suggested Appliance Adaptors*

Page 19

» Information subject to change without notice.

» Consult appliance manufacturer for additional information regarding Z-VENT

approvals of vent

and or air for U.S. and or Canada.

» Support vent and air piping within 1ft of appliance adaptors to avoid applying weight to these connections.

» Install carbon monoxide detector and alarms in accordance with local codes.

» Z-VENT

, Z-VentBlu

and NovaVent

are all UL1738 & ULC-S636 listed under UL ﬁle MH18505 and all utilizes the

appropriate Z-VENT

adaptor.

» Contact Z-Flex

U.S. Inc. at (800) 654-5600 if there is any concerns with suggested adaptor, or if you

require any additional information.

DESCRIPTION PART NUMBER

Connects 3" Z-Vent

to Safety Vent co-axial vent termination 2SVSSVA03

Connects Z-Vent

to Slant-Fin’s horizontal vent termination(part # 665-191) 2SVSSLA1

**Z-Vent

Sealant high temperature silicone sealant required to adapt some pipe to certain flues 2SILRRTV106X

Appliance with CPVC/PVC Coupling to Z-Vent

2SVSACPVC(3,4,6,8)

Appliance with CPVC/PVC Pipe to Z-Vent

2SVSACPVCF(3,4,6)

Appliance with Gasket & Clamp for CPVC/PVC Pipe x 2" Long Male to Z-Vent

2SVSTTA(023,03,04.5,06)

Appliance with Gasket & Clamp for CPVC/PVC Pipe x 4" Long Male to Z-Vent

2SVSPVC(03,04,06)

Appliance with SafTVent to Z-Vent

2SVSHF(03,04,05,06,07,08,09,10,12)

Appliance with FasNSeal to Z-Vent

2SVSAFNS(03,04,05,06,07,08,09,10,12,14)

Z-DENS to Z-Vent

2ZD2ZV(3,4,6,8)

Z-Vent

to Z-DENS 2ZDZV(3,4,6,8)

The information provided within is for informational purposes only. We have made every effort to ensure the accuracy of the provided information and assume no responsibility for any loss or

damage due to errors or omissions or to the use or misuse of any information supplied. It is impossible to test all products under all conditions to which they might be subjected in the ﬁeld. It is

therefore the buyer and/or end users’ responsibility to test all products under the conditions that duplicate the service conditions prior to installation. All improvements, all speciﬁcations are subject

to change without prior notice. It is the buyer and/or end users’ responsibility to review our complete Terms and Conditions of Sale located on our web sites at: