Manualshelf

Install Instructions

ManualsBrandsZ-FLEX ManualsPlumbing Supplies3" Z-Vent Condensation Drain (Vertical Draintee)
9101112131415161718
Page 17 of 18
APPLIANCE CONNECTION
Refer to the appliance manufacturer's installation manual for proper method of joining Z-VENT to the appliance collar. An
appliance adapter to suit specific requirements may be obtained from Z-FLEX.
IMPORTANT NOTICE
When any of the previous installation procedures are completed, be sure to go over the entire system to make sure all joints are
secure and sealed correctly. The seams and joints must be checked for tightness prior to using the venting system.
A qualified inspector must check the entire system at least once annually following initial installation to maintain the Z-FLEX
warranty. The installation must conform to the requirements of the appliance manufacturers' instructions, The National Fuel Gas
Code and local codes and regulations.