Specifications

the modem from the static-shielded bag.
6. Press the board firmly into the slot ensuring that the gold tabs on the fax/modem are aligned with the connectors in the slot.
7. Insert the screw and tighten slightly. Check to ensure that the telephone jacks in the back of the modem are unobstructed. If
so, then tighten the screw securely.
8. Replace the computer cover.
Connection:
JP1 — Internal sound card connector
l Pin 1 : Speaker Out
l Pin 2-3 : Ground
l Pin 4 : MIC Input
Installing Telephone Lines
The Fax/Modem has two modular telephone jacks on the back of the modem. You will need to connect your Fax/Modem to the wall
outlet via a modular telephone cord.
If your wall outlet is not a modular type, you can purchase an inexpensive converter at most electronics or phone stores. It is
suggested that you connect your modem to a "dedicated line". A dedicated line is a regular phone line that does not go through a
switchboard, PBX, etc.
You can also connect a telephone set to your modem, enabling you to use the phone when the modem is not in use. The modem
can also be used as an autodialer with your telephone set. It is recommended that you use a single line phone outlet (RJ11).
However, you can use a two-line (RJ14) phone line, but the modem will only work on the first line using the center pair of wires.
To connect the telephone lines to the modem follow these steps:
1. Insert one end of the phone line into the jack on the modem labeled Line.
2. Insert the other end of the phone line into the phone jack, (usually located on your wall).
If you wish to use a phone set in conjunction with your modem, Please follow these steps:
1. Insert the line from the phone into the jack labeled Phone.
2. Make sure that the other end of the phone line is connected to the telephone.
If you wish to use the speakerphone function of your modem:
1. Using a microphone with a 1/8 ” mono plug, install the plug into the jack labeled Microphone.
2. Connect speakers with a 1/8 ” stereo plug, install the plug into the jack labeled Speaker.
Testing
The actual installation of the modem is now complete. Before attempting to use your modem, you should complete the following
steps:
1. Before turning the power back on to the computer, check the telephone connection by lifting the telephone handset. You
should hear a dial tone. If you don ’ t, check that all phone cords are firmly connected.
2. Turn the computer power back on. Lift the handset of the telephone again to check for a dial tone. Once again, you should hear
a dial tone.
3. You ’ ve now completed the hardware installation of your modem. From here, you are ready to install the communications
software.
4. Once you ’ ve installed your communications software, test the modem according to the instructions in either the hardware or
software manual.