User guide

42
Figure 3.8 - Graphic and physical representation of the scanner too far from the surface
When the scanner is too close to or too far from the surface, it loses
tracking. This means that the cameras can no longer position the
targets or that the target distribution is improper. If tracking is lost,
reposition the scanner in front of a surface already scanned and
trigger again or try to redistribute the targets on the surface
differently.
Any dysfunction of the ZScanner 700 is identified by 2 red LEDS on
the top of the scanner.
TIP:
TIP:
When the scanner is too close or too far from the surface, it loses
tracking. This means that the cameras can no longer position the
targets or that the target distribution is improper. If tracking is lost,
reposition the scanner in front of a surface that has been scanned
and squeeze the trigger again, or you may need to redistribute the
targets on the surface differently.
Any dysfunction of the ZScanner 700 is identified by illumination of
the 2 red distance LEDs on the top of the scanner.