Hardware manual

ZPrinter® 650 Hardware Manual Printer Maintenance

10/21/08

7. Touch the grease gun to the Piston Screw and squeeze the trigger twice at the top of the Piston

Screw (under the Build Bed), and then squeeze the trigger once at the middle of the Piston Screw.

8. Spread the grease up and down the Piston Screw to evenly distribute it over the entire length of the

screw.

9. Move the Build Bed up and down through its full range of travel a couple of times to finish lubricating

the screw. Use the LCD menu items

BUILD CHAMBER > RAISE PLATFORM and BUILD

CHAMBER > LOWER PLATFORM

. Don’t forget to hold down the Control Knob to raise or lower the

platform.

10. Wipe off any grease that may collect at the bottom of the screw with a paper towel.

11. Replace the side and back cover panels.

12. Reset the Maintenance Counter in ZPrint.

6.3 Slow Axis Bearing Lubrication

Frequency: When prompted in ZPrint, or when you receive an Error 2303-0.

1. Locate the round plastic cover on the Deck to the left of the Build Bed and close to the Service Station.

2. Take a flat head screwdriver or a Pick Tool and pop the round cover off to expose the grease fitting. Be

careful not to scratch the deck surface. An alternative method is to reach your fingers under the left

side of the deck and pop the cover off from underneath.