Manualshelf

Hardware manual

ManualsBrandsZ Corporation ManualsComputer equipmentZPrinter 650
61626364656667686970
ZPrinter® 650 Hardware Manual Additional Operations
zcentral.zcorp.com 58 All Rights Reserved
10/21/08
5.7 Position Build Piston (Build Bed)
The Build Bed platform must be in its proper position at the top of the Build Bed in order for the printer to fill
the bed and spread a layer of powder before starting a print job. If you see the message RAISE BUILD in
the Printer Status dialog, go to the printer and select
PREP BUILD CHAMBER to raise the platform to
its proper position.
5.8 Cover
The printer cannot start a print job when the top cover is open. If the top cover is open, go to the printer and
close it. Do not open the cover while the machine is printing.