Hardware manual

ZPrinter® 650 Hardware Manual Post-Processing With Z-Bond

10/21/08

1. Place wax paper where you will be working.

2. Open the bottle and attach the spout.

3. Drizzle Z-Bond onto the part. Start with the most delicate

areas first. Wet as much of the part as you can easily

reach.

4. Reposition the part and repeat this process until the

entire part is infiltrated.

5. Quickly and thoroughly wipe any excess liquid off the

part with the paper towels and place the part on the wax paper.

6. Do not let excess liquid pool on the part as this may cause its texture to change.

7. Move the part frequently for the first few minutes. This prevents pooling of Z-Bond under the part and

the part adhering to the paper.

8. Let the part dry and cool at least 30 minutes before handling.

QSG-24