Hardware manual

ZPrinter® 650 Hardware Manual Setup And Print The Build

10/21/08

A clean, properly prepared Build Bed

2.13 Print the Build

1. Select File > 3D Print, or click on the Toolbar, to display the Printer Status dialog.

NOTE: ZPrint checks the printer readiness and calculates the materials needed to complete the

build. The results are reported in the Printer Status dialog for you to check before starting the

build.

• The dialog shows OK for each item and the Print button is enabled when the printer is ready.

• If you see a message and the Print button is not available for selection, see Chapter 5 - Additional

Operations for instructions on how to clear a message.

2. Choose your options for the build in the Print Job Options section of the Printer Status dialog.