Hardware manual

ZPrinter® 650 Hardware Manual Setup And Print The Build
zcentral.zcorp.com 29 All Rights Reserved
10/21/08
4. When you have positioned the box, click OK in the Make Fixture dialog. The Fixture is generated for
the specified area.
The fixture is shown in white on the screen.
2.10 Check the Build Layers for Errors or a Collision
It is strongly recommended that the Slice View (2D icon) and Collision Detection be utilized before
beginning a build.
The slice view is toggled on the ZPrint 3D View menu when you select the Switch Layer View /
3D View command, or by selecting the 2D icon on the Toolbar. When printing single or multiple
parts, slice viewing allows you to view the cross sections of the part(s) to identify any errors in the
file.
Collision Detection is located on the ZPrint View menu. When printing multiple parts, or a part with
a Fixture, always run Collision Detection to scan through the slices and see where layers of a part
may be overlapping or touching another part, or the Fixture.
2.11 Check The Build Settings
Before printing, always check your build settings.
1. Select File > 3D Print Setup, or click on the Toolbar.