User`s manual

ZPrint™ Software Manual Advanced Settings

11/30/09

3. Enter new values for the Layer Thickness, Shell and Core Saturation Level, Bleed Compensation,

and the Fixture Clearance.

• If you need to discard the new settings and return to the original settings, click the Reset Powder

Params button before you save your changes. After you click the Save Powder Params button,

the Reset Powder Params. button is disabled.

The example above shows the new settings for the custom powder type - ZP130A

4. To make the new powder type your default powder for all of your builds, click the Set As Default Pow-

der button. The default powder is highlighted in bold and these setting are applied to each build unless

you set a different powder type as the default.

NOTE: Custom powder type settings are saved on the local directory of your computer. If the build is

setup on a different computer, you will not have access to those powder types.

5. To delete a new custom powder, highlight the powder type and select the Delete Powder button. Con-

firm your action in the following prompt: