User`s manual

ZPrint™ Software Manual The Printer Status Dialog (ZPrinter 350/450/650

11/30/09

• The gantry reparks and the printer goes Online. Color printers will run an auto-alignment pattern

before starting the next print job to properly align the print heads.

7.4 Add Binder

ZPrint evaluates the geometry of a part and determines if there is enough binder to complete the job. If not,

ZPrint displays ADD BINDER in the Printer Status dialog. You cannot start the build until you add binder

to the printer.

NOTE: The instructions below are a general summary of the actual steps required. The steps will vary

somewhat depending on the printer you are using. Refer to the Hardware Manual for your printer.

1. Pull the old binder cartridge out of its housing on the printer and dispose of the cartridge according to

the label instructions.

2. Get a new binder cartridge and check the cartridge label for the expiration date and orientation.

3. Insert the new cartridge into its housing. Ensure the cartridge is pushed all the way in. You should feel

it gently snap into place.

• If the cartridge does not snap into place, do not force it. Check the orientation on the label and try

again. Also ensure that it is the correct color and type.

ZPrinter 350/450

ZPrinter 650

7.5 Add Powder To The Feeder

ZPrint evaluates the geometry of the part to determine if there is enough powder in the Feeder to complete

the build. If not, ZPrint displays ADD POWDER in the Printer Status dialog. You cannot start the build until

you add powder to the Feeder.