User`s manual

ZPrint™ Software Manual Print The Build

11/30/09

6.4 3D Print for Older Printers

This section applies to the Z406, ZPrinter 310 Plus/Mx, Spectrum Z510/Cx, and Z810 Printers.

The 3D Print Setup dialog may show different options available depending on the type of printer you

are using. Always check your settings in this dialog before starting a print job.

3D Print Setup Dialog for the Spectrum™ 510/Cx

1. Select File > 3D Print Setup to open the 3D Print Setup dialog. Most users will not need to change

the settings in this dialog, but if you need to, do the following:

• To change Printers, choose Select Printer. Choose a connection option and then select the Find

button to browse for the printer that is connected to your computer.

• To change the Powder Type and Layer Thickness, open the drop down list for each. The powder

types listed are those that are available for the printer displayed in the Printer field.

2. After confirming the settings for the current print job, select File > 3D Print, or click the 3D Print icon.

3. The Printing Options dialog box displays.