User`s manual

ZPrint™ Software Manual Setup The Build

11/30/09

4. Click OK. The Fixture is generated.

The fixture is shown in white on the screen.

5. Select View > Collision Detection to ensure the Fixture is not touching the part. If the Fixture is touch-

ing the part, do the following:

• Select the fixture and press Delete on your keyboard.

• Open the Make Fixture dialog and increase the Accuracy Coefficient value by 1 (one).

• Click OK to regenerate the Fixture.

• Run Collision Detection again.

5.17.3 Create a Fixture for a portion of a part

1. Select the part in ZPrint. ZPrint orients the part in the 3D View for building the Fixture.

2. Select Edit > Make Fixture.

3. In the 3D View, click on the wire frame in the top, left corner, press Shift and drag the box to an area of

the part that you want to support.