User`s manual

ZPrint™ Software Manual Setup The Build

11/30/09

• To de-select a single part, left-click once on any area in the Build Bed that does not contain the

part. When multiple parts are selected, hold down the Shift key and click directly on a part to de-

select.

• To de-select multiple parts at the same time, click once on any area in the Build Bed that does not

contain a part.

5.3.4 Selection List

Another way to select a part is by using the Selection List, which is accessed on the ZPrint Toolbar. The

Selection List will list each part that is open in an active ZPrint window.

Click the icon on the Toolbar to display the Entity Selection dialog. Click on a part to select it. To

select multiple parts, press the Ctrl button and click on multiple parts.

5.4 The Right-Button Pop-Up, Edit, And Transform Menus

After a Part file is loaded into ZPrint, it can be copied, translated, rotated, scaled, mirrored, justified, and - if

the file is a monochrome part - the entire part can be painted. These tools are available on the Right-But-

ton Popup, the Edit, and the Transform menus.

• For information about using the Make Label, Make Solid, and Make Fixture commands, please

refer to those sections later in this chapter.

5.4.1 The Right-Button Pop-Up Menu

The Right-Button Pop-Up Menu is accessed by clicking the right mouse button. It is also called the Right-

click Menu.Depending on whether a part is selected or not, different choices in the menu will be active.

•The Right Button Popup Menu is a quick-access menu of commands that are a combination of

the Edit and Transform menu commands, plus the Export .ply command, which is also on the

File menu.