User`s manual

ZPrint™ Software Manual Setup The Build

11/30/09

If a Part file opened in ZPrint is rendered dark and the slices are not visible in the cross-sectional (2D)

view, it often means the back facets of the file are showing. If this is the case, the part will not print properly.

To correct the file in ZPrint, select the part (see next section) and then select Edit > Normals > Invert All

Normals.

Normals Inverted Normals Corrected

5.3.3 Part Selection

• To select a single part in any view of the ZPrint main window, left-click directly on the part with the

mouse. A yellow wire frame appears around the part indicating that part that has the current focus.

• To select multiple parts, hold down the Shift key and left-click on each part. All selections have the

current focus when any operation is performed.

• To select all the parts in your build at the same time, choose Edit > Select All.