User`s manual

ZPrint™ Software Manual Setup The Build

11/30/09

• Fast Render parts larger than 300 thousand facets. To change this option, see Section 8.5.2

“Rendering Tab”.

If a Part file is created with dimensions that are too large for display in ZPrint, ZPrint evaluates the file and

determines the largest units that can be used for displaying the part. Choose to change the units in the

Choose Units dialog, or keep the selection that ZPrint chooses and click Next to proceed. Changing the

Display Units does not change the part dimensions, or the units the part was created with.

Important: .wrl (vrml) files will always import in meters. After importing a .wrl file, if you cannot see the

model, or see only a part of it, close the window and reopen the file. Change the Display Units to milli-

meters or centimeters when the Choose Units dialog appears.

5.3.2 Add Parts To An Existing Build

You can add multiple part files to an existing build. Select File > Import. In the Open dialog, hold down the

Ctrl key and click on multiple files to select them. When finished, click Open. ZPrint positions each subse-

quent part in the Build Bed for the fastest print times.