User`s manual

ZPrint™ Software Manual EZ Print For ZPrinter 310 Plus/DESIGNmate Mx

11/30/09

6. When Next is selected, the software creates a Fixture. It will perform Collision Detection to make sure

the Fixture and the part are not touching. If any collisions are found, ZPrint will regenerate the Fixture

with a higher accuracy level.

7. After the Fixture is created, the Ready To Print dialog appears. Click 3D Print.

NOTE: The printer must be a 310/Mx Printer and it must be connected through a serial port or a

network connection. Selecting a printer other than a 310/Mx, or an Offline printer, will not allow you

to continue in EZ Print mode.