User manual

Z Corporation Z406 System User Manual
58 Z Corporation Service [phone]/(887)88-ZCORP
8.3 SYSTEM SPECIFICATIONS
Z406 3D Printer Dimensions: 40” x 31” x 44” high (102cm x 79cm x 112cm high)
Z406 3D Printer Weight: 470 lbs. (210 kg)
Power Requirements and Operating Conditions at Site of Installation:
• Power Requirements: 100-240, 4 amps
• Operating Conditions: 68 to 85ºF, 20 to 60% Relative Humidity, non-condensing.
Lithium Battery: Internal to the Z406 3D Printer is a lithium coin cell type battery. This may be
any one of the following: Type: CR2032, either Maxell, Panasonic, Renata, Sanyo or Sony.
PLEASE NOTE: This battery is not
in a user accessible area and is not user replaceable.
The expected lifetime of the battery is in excess of five years. Replacement will be handled
by your Z Corporation customer service representative.
FCC Notice: Note: this equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interferance to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be required
to correct the interference at his own expense.
CENELEC Class A Warning: Note: this equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to EN 55022. Class A devices are for office
and light industrial environments, and are not generally suitable for home use.
WARNING: This is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.