User manual

Z Corporation Z406 System User Manual
38 Z Corporation Service [phone]/(887)88-ZCORP
Bull's eye targets, one for each
head.
When it looks well centered,
the head is in alignment.
This area warms up the heads to get
them printing evenly. It does not factor
into the alignment.
These reticules are for the fast
axis. Notice how the lines are
centered for the '0' choice.
These reticules are for the slow
axis. Notice how the lines are
centered for the '0' choice.
F1, S1 etc.
correspond to the
entries in the
dialog box.
These additional targets
will be most even when
the alignment is correct.
In this pattern, a properly aligned set has four longer lines with three shorter lines centered between them. Print
head 0 is the reference, print heads 1 through 5 are aligned to print head 0. Each row is labeled at the left, F1
and S1 correspond to Fast1 and Slow1 on the dialog box and following.