Owner`s manual

1.3 SETTING USER DEFAULT PRINTER AND POWDER
Before proceeding, we recommend setting up your default Printer and Powder. To do this, open
up the ‘3D Print Setup’ dialog box under the File menu and follow the instructions below.
1) Select the Printer that you will be using by choosing ‘Select Printer’. You may choose any
printer that is connected by serial port or network. (The network option is only available
on the Z810 3D Printer.) If the Printer is busy or offline, the option to select this printer will
not be available.
2) ‘Save Printer as Default’ enables you to save the chosen printer so that the software
remembers to use the settings for this printer when the software is reopened.
3) Choose ‘Powder Type’ by clicking on the list box. Save this powder type as the default
powder so that the printer will remember to use this powder for every print job unless
manually changed. If you would like to use a powder that is not the default, you may
manually change powder type by choosing from the ‘Powder’ list box.
[e-mail]
6