Owner`s manual
2.3.2 COPY AND PASTE
• You may make additional copies of your part
by selecting the part, then choosing the
‘Copy’ option under the Edit menu or clicking
Control (CTRL) C, and then paste the file into
the build by choosing the paste option under
the Edit menu or pressing Control (CTRL) V.
The software will allow for copying and
pasting between different builds.
• Any part copied is kept on the clipboard until
the clipboard is emptied. If you have copied
and stored a large part or several parts on
the clipboard, you may empty the clipboard
by selecting the ‘Empty Clipboard’ option
under the Edit menu. Emptying the clipboard
will reduce the amount of memory used.
• To delete any unwanted parts, select the part
and choose the Delete option under the Edit
menu or click on Delete on the keyboard.
2.3.3 BLEED COMPENSATION
• Binder printed on powder will tend to spread
slightly, causing surfaces of a part to migrate
outward. To compensate for “bleeding,” it is
necessary to perform bleed compensation on
the part, to shave off a small amount of
thickness from all surfaces.
• The Z Corp. System Software allows you to
perform this function. Choose the ‘Bleed
Compensation’ option under the Edit menu.
• The dialog box will detail the printer and
material type. To change printer or material
type, go to the 3D Print Setup. For more
information, see Section 1.3, Setting User
Default Printer and Powder.
• The Z Corp. System Software provides
recommended values for x-, y-, and z-axes.
You may override these values by typing in
new numbers. To return to recommended
values, click ‘Reset’.
PLEASE NOTE: The values will diffe
r
according to printer and material type.
service@zcorp.com
14