User manual

Z Corporation Z406 System User Manual
86 Z Corporation Service [phone]/(877)88-ZCORP
7.7 OILING THE SNOWPLOWS
Two snowplows are located between the roller on the gantry. Snowplows needs to be oiled
before every build. To oil snowplows, squeeze a few drops of oil into the wicks on the
snowplow. Snowplows need to be oiled once a week.
Wick
7.8 CLEAN UNDER THE GANTRY
Powder will adhere to the bottom surface of the gantry due to moisture accumulation. This may
cause poor surface finish and dragging of powder over the build area. To prevent dragging of
powder over the build area, it is recommended that the bottom surface of the gantry be cleaned
before every build for starch powder users and every week for plaster powder users.
1. Empty build piston of powder.
2. Put printer offline and lower build
piston.
3. Put printer online.
4. Unpark the carriage so that the gantry
can be manually moved.
5. Clean bottom surface with moist
paper towel and dry. Move gantry
manually if needed.