User manual

Z Corporation Z406 System User Manual
84 Z Corporation Service [phone]/(877)88-ZCORP
7.4 FLUSHING THE BINDER
1. If the machine is not in daily use, binder should be flushed bi-weekly for one
minute. This may be done by choosing the ‘Flush Binder’ option under the ‘Service’
menu in the ZPrint Software.
2. The LCD will display ‘Flushing Binder’
3. When finished, press the ‘Online’ button.
7.5 GREASING THE FAST AXIS
Apply grease (supplied in the tool kit) to the two grease fittings located on the fast axis rail of
the printer assembly. One full pump in each fitting should be sufficient. Wipe off any excess
grease with a paper towel. For instructions on how to assemble the grease gun, please refer to
the manufacturer’s instructions on the packaging. The software will alert you as to when to
grease the fast axis if the Maintenance Reminders feature is enabled.
Grease Fittings
PLEASE NOTE: If machine will not be in use for more than a month, replace liquid in binder
bottles with distilled water and flush the fluid system for five minutes. Then purge print heads
for two minutes. Leave the distilled water in the printer. When ready to use the Z406 3D
Printer, replace distilled water with binder and flush system for three minutes.