User manual

Z406 System User Manual Z Corporation
www.zcorp-users.com
83
6. Look at the left and right edges of
the squares. Look for the least color
fringing on the sides. For each color
choose the corresponding square in
the dialog box. In this case, the ‘0’
square would be chosen among the
blue squares. Click ‘OK’ to go on to
the vertical alignment selection.
7. Look at the top and bottom edges of
the squares with the least color
fringing. For each color choose the
corresponding square in the dialog
box. Then click ‘OK’.
8. Choose ‘Yes’ to update the printer’s alignment.
9. Remove the printed pieces, spread powder onto the build
piston, and repeat the color alignment procedure until all
squares are aligned at ‘0’.
PLEASE NOTE: You may also choose to print the ‘Part’
instead of the ‘Pattern’. The part will consist of 100 layers.
Printing the part will make it easier to see the color fringing.
Color fringing is characterized by a difference in color on the
edges from the top of the colored square (red, green, and
purple). The part with the best color match is the best
choice.
Enter the corresponding numbers into the software dialog
box, update the alignment values, and repeat if necessary.