User manual

Z Corporation Z406 System User Manual
76 Z Corporation Service [phone]/(877)88-ZCORP
7.2 ALIGNING THE PRINT HEADS
1. Place a piece of adhesive paper onto alignment
plate by removing one piece of backing, placing the
edge of the paper to the edge of the plate. Remove
the remainder of the backing slowly while placing it
down on the plate. Make sure there are no air
pockets between the paper and the plate.
2. Bring the build piston to the top, open the top cover
and place the alignment plate in the build area, to
the right and rear of the build area.
3. Close the top cover and put the printer online.
4. Select the ‘Alignment’ option under the 406Service
menu.
PLEASE NOTE: After every print head change, you must perform the alignment procedure. The software
will prompt you to align the print heads.