User manual
Z Corporation Z406 System User Manual
64 Z Corporation Service (781)852-5050/(877)88-ZCORP
6.7 FLEXIBLE PARTS
Material
• Por-A-Mold 2030
Preparation
• Read and understand the Material Safety Data Sheet, as well as any
directions.
• zp15e parts should be used.
• Be sure the parts are completely dry.
• Wear impervious rubber gloves, glasses, and a lab coat.
• Use adequate ventilation when mixing and applying the material.
Instructions
1. Material should be mixed well at an exact 1:1 ratio.
2. Apply generously. For thin parts, use a brush or syringe. Thicker parts can
be dipped.
3. If the material soaks completely into the part within a minute, apply another
coat. Multiple thin coats of elastomer will enable the part to be best
infiltrated.
4. A vacuum chamber will help the material to soak deeper into the part, but is
not required.
5. Excess material can be removed with a paper towel.
6. Let the parts sit on wax paper to cure. Make sure excess material is not dripping into a puddle on
the wax paper. This will be difficult to remove after it cures.