User manual

Z406 System User Manual Z Corporation
www.zcorp-users.com 55
6.1 GLUING MULTI-PIECE PARTS
Instructions:
1. Remove, depowder, and dry parts out of printer as described in Section 4, Post Processing
the Part.
2. Sand seams prior to gluing and check fit of any assemblies. Sanding small parts or parts
with curved surfaces can be made easier with a
small, air-powered glass air etching/sanding kit.
3. Glue seams – use of clamps can assist in the
bonding process.
4. Sand the seams after they have cured to blend and
smooth the edges. You may also fill the seams with
loose powder.
5. Priming, filling, and sanding before painting are
critical steps in the process. Achieving the best
results sometimes requires application of two coats
of primer. A wide variety of paints and primers have been successfully used for hi-quality
finishes:
• SEM products (www.semproducts.com
)
• Bondo (www.bondomarhyde.com
)
• Rustoleum Acrylic (www.rustoleum.com
)
• Interlux Brightside Polyurethane
6. You may proceed with painting the part. See
instructions below for more information on painting.
Follow all safety recommendations regarding handling, storage, venting, and personal protection
equipment when using these kinds of materials. This information can be found on the Material Safety
Data Sheet of each material.