User manual

Z406 System User Manual Z Corporation
www.zcorp-users.com 53
5.1.4 USING PARAPLAST X-TRA WAX
Paraplast X-Tra is a low viscosity, general purpose, infiltration wax formulated to melt at very low
temperatures (122°F or 50°C) and strengthen both starch and plaster parts. This material cures
rapidly and enhances the vibrancy of color parts. PARAPLAST is available in a case of eight 2.2 lb.
(1 kilogram) bag of chips. Paraplast X-Tra Wax can be used in both the ZW3 and ZW4 Waxers.
SAFETY PRECAUTIONS
• Liquid wax is hot and may cause burns. Follow all manufacturer recommended safety
precautions for your dip tank prior to use.
• Wear gloves when handling hot parts.
GENERAL APPLICATION NOTES
• Parts should be dried in an oven at 100°F (38°C) prior to infiltrating with wax for deeper wax
penetration.
• If the part is bulky, you may preheat it at 150°F (66°C) for up to 30 minutes.
• Soak part in liquid wax tank (follow all tank manufacturer’s instructions).
• Remove infiltrated part from dip tank.
• Place part in an oven at 150°F (66°C) until the wax has penetrated or melted off your part
(usually around 15 minutes).
• Be aware that these are simple guidelines. Your specific applications may require additional
steps.
CURING INFORMATION
• Allow your parts to cool after removal from the oven until the part is no longer warm to
the touch.