User manual

Z406 System User Manual Z Corporation
www.zcorp-users.com
27
3. Unscrew the lid covering the binder or
wash fluid bottle.
4. Fill the bottle up with binder or wash
fluid. Replace the lid.
5. Close front cabinet doors.
2.2.4 CHECKING POWDER OVERFLOW BIN
1. Check the overflow bin at the right side of the
machine. Slide the overflow bin out and check the
level of powder. If the powder is more than half way
full, empty the bin before proceeding.
2. Slide the bin back into place. Make sure it is pushed
all the way in.
WARNING: Do not recycle waste solution.
The waste is contaminated with powder
and use of this waste in the Z406 3D
Printer will clog the fluid system. Use
only binder and wash fluid supplied by Z
Corporation. Use of any other material
may impact the performance and safety
of your Z406 System and will void
warranty.