User manual

Z Corporation Z406 System User Manual
22 Z Corporation Service [phone]/(877)88-ZCORP
2. The build plate will project above the top of the build box. In this
position, the gantry would hit the build plate if you tried to spread
powder.
3. Lower the build piston so that the top of the build plate is slightly
below the top of the build box.
4. Spread powder over the build plate as you normally would over
the build piston.
5. Select the ‘Fill Bed’ option under the 406Service menu in the software to spread powder
automatically over the build box.
6. Vacuum up the powder on the top deck.
WARNING: If the gantry or the spread roller hits the
build plate, you may damage your printer.