User manual

Z406 System User Manual Z Corporation
www.zcorp-users.com
21
5. Vacuum up any powder spilled on the top deck.
6. Move the gantry so that it is above the feed
piston. Press and hold the feed up button until
the surface of the powder in the feed piston is
even with the top deck.
7. If using a build plate, see below for instructions.
The build plate is a useful tool in making the most out of your 3D Printer. It allows you to lift delicate
parts from the printer without handling them. It may allow you to safely remove parts from the
machine sooner after they are printed, so that you can start another build while your parts dry outside
the printer. You can use the build plate to transfer your parts to an oven to dry them quickly to their
full green strength.
1. Bring build piston all the way to the top and place build plate on
top of build piston.