User manual

Z Corporation Z406 System User Manual
20 Z Corporation Service [phone]/(877)88-ZCORP
2.2.1 FILLING THE FEED BOX WITH POWDER
3. Grip the powder scoop and using a stabbing
motion, insert it repeatedly into the loose
powder to compact it. Continue for about
10-15 seconds until the powder feels firm.
4. When feed box is filled to top, take the
tamper and slowly press it onto the powder
surface. Be careful not to “slap” the tamper
into the feed box, which will produce
airborne particles. About 10-15 pounds of
force will give a smooth, flat, and compact
surface. Failure to firmly pack feed box will
affect part quality.
1. Press and hold the feed down button until
the piston automatically moves towards the
bottom of the feed box. The piston will stop
when it reaches the bottom. Move the build
up button until it reaches the top. When
completed, the front display will read “F:
100% B: 100%”
2. Carefully scoop powder from the bucket and
place in the feed piston.
WARNING: Use only powder supplied by Z Corporation. Use of any other material may
impact the performance and/or safety of your Z406 System and will void warranty of
equipment.
PLEASE NOTE: Do not compact ZCast
powder. Use the tamper to level the
powder but do not apply any pressure.