User manual

Z406 System User Manual Z Corporation
www.zcorp-users.com
17
tip of the bottle while applying the CA, being sure not to apply the CA to the same place more
than once.
1.6.2.2 When Using a Z-Max
TM
and Z-Snap
TM
Epoxy
• If the part has delicate features, infiltrate them last as the feature will be less strong after
being infiltrated until the epoxy begins to cure. This will decrease the chance the feature will
break from the part if nudged or bumped.
• If the part has multiple delicate features or it is impossible to handle the part without breaking
a feature you may infiltrate these features only. Allow the Z-Max and Z-Snap epoxy to cure.
Then infiltrate the rest of the part. This will add time to post-processing the part but it
ensures that you have a good strong part without any fractures.