User manual

Z406 System User Manual Z Corporation
www.zcorp-users.com
115
2304 MOVER: axis %d timed out completing move
2305 MOVER: axis %d didn't settle
2400 REZERO: axis %d can't find end of travel
2501 SHAKER: bad layer number
2600 HEAD: bad ROM format
2700 DRAWSPAN: bad bit number
2701 DRAWSPAN: bad print mode
2800 TIGERCOM: serial write timeout
2801 TIGERCOM: serial read timeout
3000 SEQUENCER: bad FIFO size
Hardware problems. (Error 3008-3012)
3008 SEQUENCER: overrun while waiting for HF
3009 SEQUENCER: stalled while waiting for HF
3010 SEQUENCER: sequence didn't finish, flags = %x
3011 SEQUENCER: error in DPC, flags = %x
3012 SEQUENCER: spurious interrupt, flags = %x
3013 SEQUENCER: timed out finishing swath, flags = %x
Hardware problem with another board. (Error 4300-4302)
4300 NETWORK: can't find ethernet device
4301 NETWORK: can't get device configuration
4302 NETWORK: can't set device configuration
4400 BITBUS: object already exists
4401 BITBUS: object not initialized
4402 BITBUS: readback error
Service Station problems. (Error 4602-4603)