User manual

Z Corporation Z406 System User Manual
114 Z Corporation Service [phone]/(877)88-ZCORP
1008 Head cover is open
1009 Head %d fire voltage stuck
1010 Invalid head temperature
1100 SYSTEM: On boot up – possible bad INI variable
1207
THREAD %d: Problem occurred while trying to reboot. Cycle
the power and try again.
1800 PACKETS: layer is too big
Corrupted communications or Desktop software problem.
(Error 1901-1903)
1901 LAYERS: zlib InflateInit error %d
1902 LAYERS: zlib Inflate error %d
1903 LAYERS: zlib InflateEnd error %d
1904 LAYERS: missing layer info packet
1905 LAYERS: layer is too big – Color files with too fine resolution
2001
STRIPES: bad saturation - Wrong printer configured, check
software settings
2002 STRIPES: too many lines per stripe – Alignment errors
2003 STRIPES: line is too long
2004 STRIPES: bad print mode %d
2005 STRIPES: bad line offset
2100 UNRLE: bad layer number
2101 UNRLE: bad print mode %d
2200 BMOCO: Hardware failure (PCI Card)
2201 BMOCO: can't reset motor %d
2301 MOVER: axis %d destination out of range – Rezero problem
Obstructed or stick
y
axis. Clean and lubricate the indicated
axis - 0 = slow; 1 = fast
(Error 2303-2305)
2303 MOVER: axis %d excessive position error