User manual

Z406 System User Manual Z Corporation
www.zcorp-users.com
103
• Go to the “3D Print Setup” window under the File Menu and select zp250 powder as the
powder type.
9.2.3 PART REMOVAL AND POST PROCESSING
1. When printing parts that can be manually handled, allow the part and fixture to dry in
the build bed for at least 2 hours before removing. If printing parts that cannot be
manually handled, please refer to the Infiltration Addendum of this set of instructions.
Parts built deeper than 2 inches (50.8 mm) into the build box may require longer
drying time before handling. If the removable build plate was used the part can be
gross depowdered and removed prior to two hours and placed in an oven at 150°F
(66°C) for at least 2 hours or longer depending on the mass/volume of the part.
If a fixture was used during the printing process it should be used as a cradle for the part
during the infiltration and curing steps as well.