User manual

Z Corporation Z406 System User Manual
102 Z Corporation Service [phone]/(877)88-ZCORP
• To change the default values in the “Make Fixture” window, select “Preferences” from the
ZPrint Edit Menu and select the “Fixtures” tab. Enter the new values, and click ‘OK’.
• To create a fixture that completely cradles the entire part, raise the part in the z-axis at
least 0.5” (12.7 mm) from the bottom of the build plate in the ZPrint Software. If the part
is not raised it will not be fully support by the fixture after depowdering.