User manual

Spectrum Z510 User Manual
www.zcorp-users.com
58
8.2 Symbols Used
This is the international symbol for ‘warning’ or ‘caution’. It indicates the need to
consult your manual for further information. This symbol is in two places on the
SPECTRUM 3D Printer.
1. It is used on the rear, lower left to call your attention to the fact that only
trained personnel should open the SPECTRUM 3D Printer rear cover. None
of the normal operation procedures described in this manual require you to
remove this cover. If it is being opened to lubricate the bearings, the printer
should be turned off and unplugged prior to removing the cover.
8.3 Description of Rear Panel
Serial Port Connection: This is an RS-232 serial port for data transfer to and from the ZPrint
software. The Spectrum Printer uses 115k baud and has the same pin out as a standard PC
compatible computer. The connection to the Windows computer running the software requires
a 9 pin to 9 pin null modem cable (also known as a ‘laplink’ cable). This cable is supplied with
your SPECTRUM System; if a replacement is required, order Z Corporation part #10267.
Diagnostic Connections (Video and keyboard): These connections are used while servicing
your SPECTRUM System. Nothing should be connected to them in normal operation. The
diagnostic video connection is standard VGA output video. The keyboard connection is PS/2
style compatible.
Ethernet Connector – The Ethernet connector allows the printer to be network compatible. For
more information contact the Z Corporation Service Department at [phone] or via email
at [e-mail]
.
8.4 Material Storage Precautions
Review the Material Safety Data Sheets (MSDS) carefully before using any Z Corporation
materials.
Material Storage Usage
Powder
Store powder on pallets in a cool, dry,
ventilated area away from sources of heat,
moisture, and incompatible materials. Keep
containers tightly closed.
Use of powder in
environments with more
than 30% relative humidity
will affect powder
performance.
Binder and
Wash Fluid
Store in cool, dry place, away from sun.
Keep tightly capped.
Binder and wash fluid are
NOT recyclable.
Print Head
Store in cool, dry place, away from sun.
Infiltrants
Store in cool, dry place, away from sun.
Keep tightly capped.
For more information, visit
the User Group Website at
www.zcorp-users.com
.