User manual

Spectrum Z510 User Manual
55 www.zcorp-users.com
3. Remove syringe and place on a
paper towel to prevent binder from
dripping.
4. Empty the syringe into a waste
container.
PLEASE NOTE: Dispose of binder
fluid in accordance to company,
local, and state regulations.
5. Press ‘Cancel’ to complete bleed
air function.
6. After reinserting print heads, close
the carriage cover, and top cover.
Then run ‘Auto Alignment’ from
the Service menu.
7.8 Air has Entered into the Wash Fluid Line
You will need to use the ‘Prime Wash Fluid’ feature when there is no wash fluid or air has
entered the fluid line. This can occur in a few instances such as when first installing the
Printer, when running out of wash fluid, or when the connection to the fluid line has been
disconnected. Air can be easily detected by looking to see if there are air bubbles in the
fluid line. To remove air from the fluid line, follow the instructions below:
1. Place printer online.
2. Select ‘Prime Wash Line’ under the
Service menu.
3. Select ‘Start’.