User manual

Spectrum Z510 User Manual
www.zcorp-users.com
34
4. Remove powder away from the
buried parts, and clean powder out
of the margins against the walls of
the build box.
5. Without raising the build piston,
begin removing powder around the
part either by using the vacuum or
post-processing tools. When
vacuuming, hold the end of the
hose on a 20° to 30° degree angle
over the powder so the hose inlet
is 1/4” to 3/8” above the surface of
the powder. This generates
enough of a draft to lift loose
powder without damaging the
parts. For more information about
the post-processing tools, refer to
Section 5.2, Post Processing
Tools.
6. To gain access to the sides of the
parts, raise the build piston by
holding down the build up button.
7. When finished, you
may remove the part
by hand or press the
‘Build Up’ button on
the control panel.
When it stops
moving, press ‘Build
Up’ one more time to
initiate the unload
feature. The build
plate will now be
exposed and easy to
lift off the build
envelope.