User manual

Spectrum Z510 User Manual
33 www.zcorp-users.com
6. Soft Acid Brush: This part can also be used to remove
caked powder from hard to reach areas and the soft
bristles make this brush perfect for delicate features.
5.3 Removing the Finished Part
After the build is complete, remove the finished parts from the build box as follows:
1. Leave the part in the bed for
approximately 30-60 minutes.
Take a moment to look at the
computer screen and determine
exactly where parts lie in the build
box.
2. Take the printer
offline by pressing
the ‘Online’ button
and lift the top cover.
3. Press the feed down
button to lower the
feed piston.